From 15a147e61898d25ec8b539190e87f3a09592c9c8 Mon Sep 17 00:00:00 2001 From: Martin von Zweigbergk Date: Wed, 9 Feb 2011 20:54:02 -0500 Subject: rebase: use @{upstream} if no upstream specified 'git rebase' without arguments is currently not supported. Make it default to 'git rebase @{upstream}'. That is also what 'git pull [--rebase]' defaults to, so it only makes sense that 'git rebase' defaults to the same thing. Defaulting to @{upstream} will make it possible to run e.g. 'git rebase -i' without arguments, which is probably a quite common use case. It also improves the scenario where you have multiple branches that rebase against a remote-tracking branch, where you currently have to choose between the extra network delay of 'git pull' or the slightly awkward keys to enter 'git rebase @{u}'. The error reporting when no upstream is configured for the current branch or when no branch is checked out is reused from git-pull.sh. A function is extracted into git-parse-remote.sh for this purpose. Helped-by: Yann Dirson Helped-by: Jonathan Nieder Signed-off-by: Martin von Zweigbergk Signed-off-by: Junio C Hamano --- git-pull.sh | 32 ++++---------------------------- 1 file changed, 4 insertions(+), 28 deletions(-) (limited to 'git-pull.sh') diff --git a/git-pull.sh b/git-pull.sh index eb87f49062..2cdea26265 100755 --- a/git-pull.sh +++ b/git-pull.sh @@ -163,34 +163,10 @@ error_on_no_merge_candidates () { echo "You asked to pull from the remote '$1', but did not specify" echo "a branch. Because this is not the default configured remote" echo "for your current branch, you must specify a branch on the command line." - elif [ -z "$curr_branch" ]; then - echo "You are not currently on a branch, so I cannot use any" - echo "'branch..merge' in your configuration file." - echo "Please specify which remote branch you want to use on the command" - echo "line and try again (e.g. 'git pull ')." - echo "See git-pull(1) for details." - elif [ -z "$upstream" ]; then - echo "You asked me to pull without telling me which branch you" - echo "want to $op_type $op_prep, and 'branch.${curr_branch}.merge' in" - echo "your configuration file does not tell me, either. Please" - echo "specify which branch you want to use on the command line and" - echo "try again (e.g. 'git pull ')." - echo "See git-pull(1) for details." - echo - echo "If you often $op_type $op_prep the same branch, you may want to" - echo "use something like the following in your configuration file:" - echo - echo " [branch \"${curr_branch}\"]" - echo " remote = " - echo " merge = " - test rebase = "$op_type" && - echo " rebase = true" - echo - echo " [remote \"\"]" - echo " url = " - echo " fetch = " - echo - echo "See git-config(1) for details." + elif [ -z "$curr_branch" -o -z "$upstream" ]; then + . git-parse-remote + error_on_missing_default_upstream "pull" $op_type $op_prep \ + "git pull " else echo "Your configuration specifies to $op_type $op_prep the ref '${upstream#refs/heads/}'" echo "from the remote, but no such ref was fetched." -- cgit v1.3